154
Description
Use the schedule reboot delay command to enable the scheduled reboot function
and set a reboot wait time.
Use the undo schedule reboot command to disable the scheduled reboot function.
By default, the scheduled reboot function is disabled.
The reboot wait time can be in the format of hh:mm (hours:minutes) or mm (absolute
minutes). The absolute minutes cannot exceed 30 x 24 x 60 minutes, namely, 30 days.
The precision of the device timer is 1 minute. One minute before the reboot time, the
AC will prompt REBOOT IN ONE MINUTE and will be rebooted in one minute.
After you execute the above command, the AC prompts you to confirm the
configuration. You must enter Y or y to make the configuration take effect. The original
configuration is overwritten at the same time.
If you use the clock command after the schedule reboot delay command to adjust the
system time, the reboot wait time set by the schedule reboot delay command
becomes invalid.
If you are performing file operations when the AC is to be rebooted, the system does
not execute the command for the sake of security.
CAUTION:
This command reboots the AC after the specified delay time, resulting in service interruption.
Please use it with caution.
Examples
Configure the AC to reboot in 88 minutes (supposing the current time is 11:48).
<Sysname> schedule reboot delay 88
Reboot system at 13:16 06/06/2006(in 1 hour(s) and 28 minute(s)) confirm?
[Y/N]:
If you have used the terminal logging command to enable the log display function on
the terminal before setting a reboot time, the system will automatically display related
log information after you enter y. By default, the log display function is enabled on the
terminal.
<Sysname>
%Jun 6 11:48:44:860 2006 Sysname CMD/4/REBOOT:
vty0(192.168.1.54): Set schedule reboot parameters at 11:48:44 06/06/2006, and
system will reboot at 13:16 06/06/2006.
To Next Page
Loading...
Need help?
General
