Harmonic ProView 7100 - Device Identification; Reset CAM Slot; HDMI and DVI Output; Reboot Device

Chapter 7 Device Configuring Using EMS Device Management
© 2012 Harmonic Inc. 146 ProView 7000 v.2.6, Rev. E
■ Backing Up/Restoring the Device Configuration
■ Restoring the Factory/Default Device Access Passwords
7.10.1 HDMI and DVI Output
You can attach a video monitor to the HDMI port to monitor decoded video. The HDMI port
supports HDMI and DVI modes.
To change the mode of the HDMI port:
1. Right-click HDMI Monitor Video Port 1 under Decoders in the Physical Output box.
2. Select Properties in the drop-down menu.
The HDMI Monitor Video Port 1 properties dialog displays.
3. Select one of the following modes in the Output Mode drop-down menu:
❑ HDMI
❑ DVI
The default is HDMI.
7.10.2 Reboot Device
To reboot a device:
1. Select the device in the Devices box.
2. Select Tools > Reboot Device.
3. Confirm.
7.10.3 Device Identification
You can blink the front panel LCD backlight of a physical device to identify it amongst other
devices on a rack.
To identify a device:
1. Select the device in the Devices box.
2. Select Tools > Device Identification Blinking Light.
3. Click Start Blinking in the dialog.
To stop blinking:
❖ Click Stop Blinking in the dialog.
7.10.4 Reset CAM Slot
To reset a CAM slot:
1. Select the device in the Devices box.
2. Expand the Descrambling branch in the Physical Input box.
3. Right-click a CAM slot.
4. Select Reset CAM Slot.