Harmonic ProView 7100 - CA Definitions

Chapter 4 Device Configuring Using the Front Panel CA Definitions
© 2012 Harmonic Inc. 53 ProView 7000 v.2.6, Rev. E
4.5 CA Definitions
Use the CA Definitions menu to configure BISS and associate multiplexes to CAMs and select
individual programs.
To access the CA Definitions menu:
❖ Navigate Root > CA Definitions.
The CA Definitions menu comprises configuration sub menus.
4.5.1 BISS
Use the BISS menu to disable BISS descrambling, to define BISS keys or to clear BISS keys.
Sub menus:
■ Activation
■ Key Configuration
4.5.2 CAM 1/2 Sub Menu
The CAM slot sub-menus each comprise:
■ CAM Association – Use to associate the CAM slot with a multiplex in.
■ Max CAM Bitrate – 72 or 96 Mbps depending on hardware configuration. The default is 72.
■ CAM De-Jittering – Enable or disable.
■ Automatic Recovery Policy – Use to configure the ProView 7000™ to reset the CAM when
one of the following alarms is raised:
❑ CAM Descrambling Failure
❑ CAM Processing Failure
❑ Packet Loss after Descrambling
■ CAM MMI – Use to access the MMI (Man Machine Interface).
4.5.3 CAM Association
To associate a CAM with a multiplex:
1. Navigate Root > CA Definitions > CAM (1–4).
2. Select CAM Association.
3. Select a multiplex, TS1, TS2, TS3 or TS4.
4.5.4 Selecting All Elementary Streams
To select all elementary streams for configuring:
1. Navigate Root > CA Definitions > CAM (1–4) > Descrambling Mode.
2. Select Full.