Harmonic ProView 7100 - Device Properties

Chapter 7 Device Configuring Using EMS Device Properties
© 2012 Harmonic Inc. 153 ProView 7000 v.2.6, Rev. E
7.11 Device Properties
Use the Device properties to monitor and set ProView 7000™ system level parameters.
To display the Device properties:
1. Select a device icon in the Devices box.
2. Click Properties on the EMS toolbar.
The Device Properties dialog displays with multiple tabs, each listing a specific group of
device parameters.
Related topics:
■ Network Properties
■ Hardware Properties
■ Device Communication Properties
■ Device Users’ Access Properties
■ Device Software Upgrade Properties
■ Device License Properties
■ Device Date and Time Properties
■ GPI Properties
7.11.1 Network Properties
The Network properties tab provides the EMS user the ability to manage the following
parameters related to the ProView 7000™ unit:
■ Set the IP address of the port.
■ Set the Mask address of the port.
■ Set the Gateway address of the port.
■ View the unit MAC Address.
■ View Auto negotiation status of the port.
■ View the traffic Speed of the port (in Mbps).
■ View the Duplex Mode.
■ Manage the Routing Tables – GbE In mode only.