© 2012 Harmonic Inc. 63 ProView 7000 v.2.6, Rev. E
Chapter 6
Remote Management using EMS
The ProView 7000™ EMS application provides a GUI for easy remote management of
ProView 7000™s.
Topics:
■ Configuring the IP Parameters
■ EMS System Requirements
■ Installing EMS
■ Launching EMS
■ Adding a Device
■ Connecting a Device
■ Checking Device Connectivity
■ Disconnecting a Device
■ Removing a Device
■ Displaying the Device Explorer
■ EMS GUI Structure
■ Manipulating EMS GUI Components
■ Refreshing the EMS Screen
6.1 Configuring the IP Parameters
Before you can manage a ProView 7000™ remotely, you must configure the IP parameters.
To configure the IP parameters of a ProView 7000™:
1. Press Enter on the keypad.
The root menu displays.
2. Navigate Unit > Management Port > IP Configuration.
3. Set the IP Address, Subnet Mask and Default Gateway for the port.
4. After any change in the IP configuration, the Apply port changes item is added to the IP
Configuration sub-menu to allow confirmation of the port setup.
IP Configuration
1 IP Address
127.000.000.010
2 Subnet Mask
255.255.255.000
3 Default Gateway
000.000.000.000
To Next Page
Loading...