Chapter 6 Remote Management using EMS Changing a Device’s Connection Settings
© 2012 Harmonic Inc. 66 ProView 7000 v.2.6, Rev. E
4. For automatic connection when launching the EMS, mark the Connect Device
checkbox.
5. For SNMP settings click Advanced.
6. Enter a Timeout value for defining the maximum time period for one connection attempt.
This parameter is set to 20000 (msec) by default.
7. Enter a Retry value for setting the number of connections attempts in case of a
connection failure. This parameter is set to 2 tries by default.
8. Click OK to save advanced parameters.
The Advanced dialog closes and the EMS returns to the Add ProView 7000™ Device
dialog.
9. Click Add.
6.6 Changing a Device’s Connection Settings
You can change the identification, automatic connection and SNMP settings of devices
already added to EMS.
To change a device’s connection settings:
1. Right-click the device in the Devices box.
2. Select Preferences.
3. Edit the name or IP address.
4. For automatic connection when launching the EMS, mark the Connect Device
checkbox.
5. For SNMP settings click Advanced.
To Next Page
Loading...
