Harmonic ProView 7100 - Unit Menu

Chapter 4 Device Configuring Using the Front Panel Unit Menu
© 2012 Harmonic Inc. 54 ProView 7000 v.2.6, Rev. E
4.5.5 Configuring Only Relevant Elementary Streams
The descrambling mode default is Selective.
To set the CAM to Selective mode to configure only relevant elementary streams:
1. Navigate Root > CA Definitions > CAM (1–4) > Descrambling Mode.
2. Select Full.
4.5.6 Accessing the CAM MMI Menu
To access the CAM MMI menu:
❖ Navigate Root > CA Definitions > CAM (1–4) > CAM MMI.
4.6 Unit Menu
Use the following Unit menu items to configure and monitor ProView 7000™s:
■ Management Port Menu
■ SW Version Menu
■ HW Inventory Menu
■ Date/Time Menu
■ Set Active Version
■ License
■ BOOTP Menu
■ LCD Contrast Menu
■ GPI Menu
■ Reset Unit Menu
■ Restore to Defaults Menu
4.6.1 Management Port Menu
Use the Management Port menu to configure the management port.
To access the Management Port menu:
❖ Navigate Root > Unit > Management Port.
Each option in the menu leads to value setup screen (i.e., selecting the option displays either
an edit value screen - to set a new value or a select value screen with radio button options).
The Management Port configuration menu provides the following options:
■ IP Configuration – manages the IP configuration of the GbE port. The sub-menu manages
the following parameters:
❑ IP Address – sets the IP address of the port.
❑ Subnet mask – sets the network subnet mask address for the port.
❑ Default Gateway – sets the network default gateway address. This is the address of a
local IP router on the same network as the ProView 7000™, which is used to forward
traffic beyond the local network.
■ MAC Address – displays the media access control (MAC) address for the device.