Cleaning the Feeder Belts and Rollers
Follow the steps below to clean the belts and rollers of the feeder.
How to Clean the Feeder Belts and Rollers
To clean the feeder belts and rollers:
1. Open the Auto-Feeder cover, press the upper blue handle to raise the drive assembly.
2. Clean the belts and/or rollers with a damp cloth or 70° alcohol on a cotton applicator.
3. Push down the upper drive assembly until it locks back into position and close the
feeder cover.
Cleaning Mail Path Sensors
The sensors are light sensitive devices successively covered by the envelopes during their
travel along the mail path.
Clean the mail path sensors as indicated below on system base and feeder.
10
Maintaining your Mailing System
215
| Page 215 | feb-14-2014 12:06 |
To Next Page
Loading...
