Filling and Adjusting the Feed-
er Sealer
10.2
Filling the Sealer Bottle
The Automatic Feeder uses water for sealing envelopes.
If the system is out of water, the mailing process continues but the envelopes will not sealed
properly.
How to Fill the Sealer Bottle
To add water (or sealing solution) to the bottle:
1. Remove the bottle from its base and turn it over.
2. Unscrew the cap and fill the bottle with water up to the limit marks.
3. Screw the cap back and put the bottle back into place.
211
| Page 211 | | feb-14-2014 12:06 |
10
Maintaining your Mailing System
To Next Page
Loading...
