Hasler IM440 PLUS - Maintenance Processes

Maintenance Processes10.4
Maintenance Processes
The maintenance processes listed below are only to be completed on request from by
Customer Service.
Check that your Mailing System is connected to a telephone line or the LAN before starting.
As supervisor (see How to Log in as Supervisor on page 148 ):
Press and type 7.4 or select the path:
Maintenance Processes
Processes list
1.
Installation Process
-
First time installation of your system.
2.
Remove the Base
-
Remove the base from service.
-
Prepares the base for removal by saving data on USB key.
3.
Swap base
-
Install a replacement base.
4.
Withdraw the PSD
-
Remove PSD from service.
-
Requires a password from Customer Services to perform.
5.
Swap the PSD
-
Allows installation of a new PSD in mail system. Old PSD must have already
been withdrawn.
6.
Update Registration
-
This procedure is used if you have changed your address.
-
Contact your Customer Service to change your information then you will be
instructed to perform the update registration procedure.
217
| Page 217 | | feb-14-2014 12:06 |
10
Maintaining your Mailing System