4
2. Use the equipment under the following electrical specifications.
Power supply voltage: Single phase AC 100–240 V ±10%
Frequency: 50 to 60 Hz
Consumption current: 3–1.3 A
Type of protection against electrical shock: CLASS 1 EQUIPMENT
3. Use an independent outlet separate from other equipment.
4. At least 4 inches (10 cm) of clearance is required on all sides of the analyzer.
5. Unplug the equipment from the AC outlet if it will not be used for an extended period of time.
CAUTION
Hold the handle of the device when lifting or moving it.
CAUTION
• When moving the device to another installation location, remove all slides, samples, diluent, reference fluid, mixing
cups, tips, and other consumables beforehand.
• Do not set the device on its side or upside down while moving it.
• Place the device on a flat and stable stand.
• When the device is subject to vibrations, such as when being moved by vehicle, it is necessary to secure the moving
parts within the device. Contact Heska Technical Support Services.
Failure to observe these precautions may result in unexpected errors or equipment malfunctions.
1.9 Measurement Results
IMPORTANT
Make a diagnosis in a comprehensive manner, considering other relevant test results or clinical symptoms.
IMPORTANT
When an equipment problem (error) appears before or during measurement, or a warning appears in the measurement
results, the measurement results may not be accurate. Refer to Section 7: Troubleshooting, and then rerun the
measurement.
1.10 DRI-CHEM Slides
NOTE: For the remainder of the manual, DRI-CHEM Slide is shortened to “slide”.
IMPORTANT
• The slides should be stored in a refrigerator still wrapped to avoid humidity, light, and heat.
• Remove the required number of slides from the refrigerator, and allow them to reach room temperature before
unwrapping and using them.
• Complete the measurement within 30 minutes after unwrapping the individual package.
Handles
To Next Page
Loading...
