3
CAUTION
Do not use other devices which generate and can radiate radio frequency energy near the Element DC5X Analyzer.
Otherwise, physical damage or malfunction on the Element DC5X Analyzer may occur.
1.7 Caution Regarding Moving Parts
WARNING
Do not place your fingers near moving parts (sampler and sample disk) when operating the equipment, including during
maintenance.
Also use care and do not get your fingers, hair, clothing, or accessories caught in moving parts.
WARNING
During sample processing, ensure the sampler cover is closed to prevent injuries and biohazards. If your finger touches a
tip that has sample inside, the sample may spill out from the tip. When the display reads [Ready to test], the sampler cover
can be opened.
1.8 Installation Locations
WARNING
Plug the power cable of the equipment into an outlet with a grounding receptacle. Electrical shock may occur if the outlet
is not grounded.
CAUTION
Avoid the following installation sites.
• Places where spills or water leakage may occur.
• Places where the equipment is exposed to direct sunlight.
• Places near sources of heat such as heaters.
• Places where the temperature may drastically change.
• Places where the equipment is subject to vibration or is unstable.
1. Install the equipment in the following environmental conditions.
Installation environment:
Illumination:
Indoor use (do not expose to direct sunlight)
6,000 cd/m
(lux) or less (3,000 cd/m
(lux) or less when
using the sample barcode reader)
Atmospheric pressure: 810 hPa or more, equivalent altitude 6,562 ft (2,000 m)
Transient overvoltage category: II
Pollution degree: 2
Operating temperature: 59°F–89°F (15°C–32°C)
Operating humidity: 30% RH–80% RH (no vapor condensation)
To Next Page
Loading...
