Hettich HettCube 200 - Page 127

127 / 174
en
12.2020 / Rev. 02
AB66005
Troubleshooting
No. Fault description Cause Remedy
If the error appears again: Call
Service; Pr
ovide the device type,
serial number and error number.
3 Error 3 Sensor measured value below
the valid measuring range.
Call Service; Provide the device
type, serial number and error
number.
4 Error 4 Sensor measured value above
the valid measuring range.
Call Service; Provide the device
type, serial number and err
or
number.
5 Error 5 No measured value from the
sensor
.
Call Service; Provide the device
type, serial number and error
number.
6 Error 6 Calculation error Call Service; Provide the device
type, serial number and error
number.
7 Error 7 Calculation error Call Service; Provide the device
type, serial number and err
or
number.
10 Error 10 Connection to the temperature
sensor was interrupted or the
sensor is defective.
Call Service; Provide the device
type, serial number and err
or
number.
12 Error 12 Error value in acc. with standard
IEEE-754.
Call Service; Provide the device
type, serial number and error
number.
13 Error 13 Error value in acc. with standard
IEEE-754.
Call Service; Provide the device
type, serial number and err
or
number.
14 Error 14 Error value in acc. with standard
IEEE-754.
Call Service; Provide the device
type, serial number and error
number.
15 Error 15 Controller signals a µC error. Call Service; Provide the device
type, serial number and err
or
number.
16 Error 16 Memory issue Call Service; Provide the device
type, serial number and err
or
number.
17 Error 17 Memory issue Call Service; Provide the device
type, serial number and error
number.
18 Error 18 Memory issue Call Service; Provide the device
type, serial number and error
number.