Fig. 88: ‘Manual mode
Start
Start
delay
Countdown’
1 Countdown
Fig. 89: Manual mode active
1 HettCube activities area
Fig. 90: ‘Manual mode
Settings’
4. After a few seconds, the display will switch to the main screen.
Ther
e, a countdown is displayed until the start of manual
mode.
NOTICE
When the countdown is running, it is not pos-
sible to change the manual mode settings. T
o
start a program, rst stop the countdown.
6.11.3 Manual mode changes during running operation
Y
ou can make the following changes while manual mode is running:
■ Edit the temperature setpoint in the interior
■ Activate/deactivate and edit the temperature drop
■ Activate/deactivate PIN protection
■ Activate/deactivate control contact
T
o make changes while manual mode is running, proceed as follows:
1. Tap the main screen in the HettCube activities area.
2. Make the corresponding settings as described in the chapter
Chapter 6.11.1 ‘Manual mode settings’ on page 54
.
To Next Page
Loading...
