Fig. 84: ‘Manual mode
Set
temperature
Keypad entry’
1
[Clear input]
button
2 Keypad
2.
Fig. 85: ‘Manual mode
Start’
1
[Start manual mode]
button
Fig. 86: ‘Manual mode
Start
Main
screen’
Fig. 87: ‘Manual mode
Start
Start
delay’
You can now either
■ select the existing value by tapping it and entering a new
value via the keypad or
■ delete the existing value with the
[Delete entry]
button and
entering a new value via the keypad.
Conrm the entry with the
[Conrmation]
button.
6.11.2 Starting manual mode
T
o start manual mode, proceed as follows:
1. Make all settings for manual mode
Chapter 6.11.1 ‘Manual
mode settings’ on page 54
.
2. Start manual mode with the
[Start manual mode]
button.
NOTICE
A temperature guard is always activated and
cannot be switched of
f. If the temperature set-
point lies outside of the temperature range of
set temperature guards, an error message is
displayed when manual mode is started.
If no start delay for manual mode was selected, you will go
to the main scr
een.
3. If a start delay was specied, a message indicating when
manual mode will start will appear befor
ehand.
To Next Page
Loading...
Need help?
General
