Unloading from the pallet, HettCube
400/400 R and HettCube 600/600 R
5 Commissioning
■ Ventilation openings may not be covered or blocked.
■ Before commissioning, check to make sure the mains voltage is
corr
ect according to the nameplate and that the mains cable is
connected properly.
■ If necessary, additional devices and accessories can be mounted
and/or connected.
Every time befor
e using the incubator, make sure that
■ the incubator is dry.
5.1 Unpacking the incubator
When lifting up the incubator, note the specied
weight and only lift the incubator with a suitable
number of helpers to avoid injuries.
Please check the device and outer packaging before
unpacking. Any transport damage must be reported
immediately.
1. Remove the packaging bands.
2.
The packaging can be easily removed, even if
the room has a low ceiling. If handled carefully,
the cardboard box can be reused.
Remove the cardboard box and padding material.
The padding on the inside of the door serves
as a transport safety device for the slide-in
modules and drawers. This padding may be
removed only at the installation site of the incu-
bator.
WARNING
There is a tilting hazard when removing the incubator
fr
om the transport pallet.
There is the danger that the incubator will tilt if it is
attempted to remove it from the transport pallet
without the included auxiliary equipment. Personnel
can also be injured by the tilting incubator.
− Remove the incubator from the transport pallet
only with the help of the metal rails included in
delivery
.
− Observe the information in these instructions.
To Next Page
Loading...
Need help?
General
