Fig. 121: ‘Program mode
Creating a
program
Editing a program’
6.12.4 Copying and deleting a program
Change to the ‘Program mode settings’ menu
Chapter 6.12.1 ‘Program mode settings’
on page 69, select the program to be edited from
the program list and press the [Edit program] button.
If you are already in the ‘Edit program’ menu, you
can continue with editing the program name
‘Editing the program name’ on page 71.
Item Designation Description/function
1
[Conrmation]
button After you have made all settings, you can conrm this with
this button.
2
PIN protection
‘PIN protection’
on page 85
To protect the program from being changed, you can acti-
vate/deactivate the PIN protection here.
3 Program name Indicates the currently assigned program name.
4
[Edit program name]
button
‘Editing the program name’
on page 71
After pressing the button, you can edit the program name.
5
[Cancel]
button If the
[Cancel]
button is pressed, the dialogue is closed and
you will go back to the previous dialogue. All changes will
be discarded.
6
[Add new program segment]
button
A new program segment is created by tapping this. The
new program segment is created with 37°C and one hour
run-time.
7
‘Total run-time’
display Shows the run-time for the entire program.
8
‘Date and time of program end’
display
Shows the date and time of the end of the program.
9
Program segment
‘Editing a
program segment’ on page 71
Shows a program segment. The program segments are run
from left to right.