Hettich HettCube 200 - Creating a Program

en
12.2020 / Rev. 02
AB66005
70 / 174
Operation
Fig. 94: ‘Program mode

Creating a
program’
1 [Create program] button
Fig. 95: ‘Program mode

Creating a
program

New program’
1 Program name
2 Precongured standard program
segment
Item Designation Description/function
5
[Delete] button

Chapter 6.12.4
‘Copying and deleting a program’
on page 81
When this button is tapped, the currently activated program
will be irrevocably deleted.
6
Program segments

‘Editing a
program segment’ on page 71
The program segments can be scrolled horizontally to the
left and right to get an overview of the temperature setpoint
as well as the program segment duration, the control con-
tact and the standstill segments.
7
[Create program] button

Chapter 6.12.2 ‘Creating a pro-
gram’ on page 70
A new program is created by tapping this. The new pro-
gram is created with a precongured program segment
with 37°C and one hour run-time.
8
[Copy] button

‘Copying a pro-
gram’ on page 82
When this is tapped, the currently selected program is
copied.
6.12.2 Creating a program
To create a program, proceed as follows:
1. Tap the [Create program] button.

A new program is created. The program is given the name
‘New programx’ . A precongured standard program seg-
ment is created with 37°C and one hour run-time.
2. The created program can now be edited

‘Editing a program’
on page 78 .