258
Performing Remote Operation Using the HTTP Server
Displaying measured values
You can check current measured values in a browser.
3
2
4
5
1
Launch Internet Explorer
®
on the computer.
2
Enter the instrument’s address into the address bar (for example, )
3
Click [INSTANT DATA DISP].
Current measured values will be displayed.
4
Under [SELECT UNIT], select the unit whose values you wish to display.
Measured values for each of the selected unit’s channels will be displayed.
• Depending on communications conditions, it may take 2 to 3 s to acquire data.
• Values are not shown for channels whose display has been disabled.
• When measurement is stopped, the instantaneous data being input to each channel will be
displayed.
5
Under [REFRESH INTERVAL], set the refresh time for the screen.
OFF
, 1 s, 5 s, 10 s, 30 s
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
