337
Terminator Can be enabled/disabled for each port.
Resistance value: 120
±10
ACT LED Displays the CAN bus operating status.
TERM LED Illuminates when the terminator is enabled.
Data refresh interval 10 ms, 20 ms, 50 ms, 100 ms, 200 ms, 500 ms, 1 s, 2 s, 5 s, 10 s
Baud rate
Sampling point
ACK
Operating mode Can switch between receive mode and measured value output mode.
-2. Receive mode specications
Number of channels Data refresh interval 10 ms: Up to 50 channels (up to 50 signals)
Data refresh interval 20 ms: Up to 100 channels (up to 100 signals)
Data refresh interval 50 ms: Up to 250 channels (up to 250 signals)
Data refresh interval 100 ms or longer: Up to 500 channels (up to 500 signals)
Receive ID count
interval
User frame
transmission
Overview Sends user CAN frames while operating in receive mode.
Number of sets of
conditions that can be set
8 conditions per unit
-3. Measured value output mode specications
Overview Converts LR8450 measured values into CAN frames and outputs them.
Output target Measurement data from plug-in modules (other than CAN Units)
Output data refresh
period
Varies with the data refresh interval for the units whose data is being output (as short as
1 ms).
Response (Data refresh interval) × 2 + 1 ms + (analog response time*)
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
