Hioki RM2610 - Initializing the Software

111
Initializing the Software
9.3 Initializing the Software
This section describes how to reset the RM2612 Resistance Calculation Software to its factory
defaults.
IMPORTANT
Clicking [Initialize conguration] will reset all settings other than those listed below to the factory defaults.
Follow the instructions in “6.1 Saving Measurement Conditions” (p. 73) as necessary before initializing the
software.
Settings that are not initialized: Communications settings, counter, password
1
2
3
4
1
Choose [Settings].
2
Choose [System].
3
Click [Initialize Conguration].
4
4
Click [OK].
The software will be initialized.
10
9
7
6
5
4
3
2
1
索引
8
Maintenance and Service