Hioki RM2610 - Choosing the Model Area

59
Choosing the Model Area
4.8 Choosing the Model Area
This section describes how to choose a model area according to the measurement precision you
require. Although measurement precision increases in proportion to the model area, measurement
times will increase as well.
1
2
3
4
1
Choose [Settings].
2
Choose [Analysis].
3
Choose one of the following settings for [Model area]:
NORMAL

Perform analysis using the standard model area.
MEDIUM Perform analysis using a model area that is about 2.5 times greater
than the standard area (NORMAL).
WIDE Perform analysis using a model area that is about 4 times greater
than the standard area (NORMAL).
4
Click [Apply] or [OK] to accept the settings. (Clicking [OK] will cause you to return to the
main screen.)
What is model area? (p. 97)
Although increasing the model area setting will allow you to make measurements that more closely
approach actual physical phenomena, measurement times will increase. Change the setting to
reect the degree of measurement precision that you require.
4
Customizing Measurement Conditions