121
10
Appendix
10.1 Rack Mounting
The screws on the sides of the RM2611 Electrode Resistance Meter can be removed and used to
attach rack-mounting hardware.
WARNING
To prevent damage to the RM2611 Electrode Resistance Meter or electric shock,
exercise care with regard to the following precautions concerning the type of
screws used:
When installing rack-mounting hardware onto the sides of the instrument, ensure
that the screws do not protrude into the RM2611 Electrode Resistance Meter
more than 3.5 mm. When removing the rack-mounting hardware to return the
instrument to its original state, use the same screws that were installed when it
shipped from the factory.
(Support legs: M3 × 6 mm; sides: M4 × 6 mm)
If you lose or damage the screws, please contact your authorized Hioki distributor
or reseller.
10 Appendix
10
Appendix
To Next Page
Loading...
