Hioki RM2610 - Rejecting Error Data During Measurement (Error Data Rejection Function)

53
Rejecting Error Data during Measurement (Error Data Rejection Function)
4.3 Rejecting Error Data during Measurement (Error
Data Rejection Function)
You can reject error data during measurement. Measurement will continue until a set threshold is
exceeded, even if current errors, over-range errors, or contact errors are encountered.
Rejected error data
• Data with current errors
• Current channel data with a consistency result of FAIL
• Potential data from probes with contact errors
1
2
3
4
5
1
Choose [Settings].
2
Choose [Measurement].
3
Choose one of the following settings for [Error data rejection]:
ON Reject error data.
OFF

Do not reject error data. (Skip step 4 below.) Potential measurement
will stop if a single probe generates a contact error or if a single
potential measurement step generates an error.
4
Customizing Measurement Conditions