112
Initializing the Software
Factory default settings
Setting Initial value
Measurement conditions
Auto range ON
Resistance range 1000 k
Ω
(10 μA)
Electrode sheet information
Composite layer thickness [μm] 50
Collector thickness [μm] 20
Collector volume resistivity [
Ω
cm] 2.7000E-06
Comment (Blank)
File output
Analysis results OFF
Potential for analysis OFF
Analysis results path (User desktop)
Potential for analysis path (User desktop)
System
Communications settings (Device if connected)
Measurement
Operating mode Potential measurement + analysis
Measurement speed MEDIUM
Contact check ON
Threshold [
Ω
] 2.000E+04
Auto start OFF
Delay time [ms] 500
Error rejection OFF
Error tolerance [%] 20.0
Composite layer units Volume resistivity [
Ω
cm]
Beep at measurement completion ON
To Next Page
Loading...
