CHASSIS
- 224-
INSTALLING THE FRONT AND REAR
BRAKE
CALIPERS
The following procedure applies to both of the
brake calipers.
1. Install:
• brake caliper assembly
• brake caliper mounting bolts
48Nm (4.8m · kg,35 ft · lb)
• brake hose ①
• copper washers ②
• union bolt ③
1NOTE:
When installing the brake hose on the
brake caliper, make sure that the brake
pipe touches the projection a on the brake
caliper.
WARNING
：
Proper brake hose routing is essential to
insure safe vehicle operation.
2. Fill:
• brake reservoir
Must use DOT4 Brake Fluid
1NOTE:
Brake fluid may damage painted surfaces
or plastic parts. Always clean up spilled
brake fluid immediately.
3. Air bleed:
• brake system
4. Check:
• brake fluid level
Brake fluid level is below the “MIN” level line
Add the recommended brake fluid to the
proper level.
To Next Page
Loading...
