CHASSIS
- 244-
INSTALLING THE WHEEL TYRE
1. Install:
• wheel
1NOTE:
The arrow mark ① on the tyre must point in
the direction of rotation □
A
of the wheel.
2. Tighten:
• wheel nuts ①
The angle of the conical bores is 60°
1WARNING
：
Tapered wheel nuts ①
are used for both the
front and rear wheels. Install each nut
SPECIFICATION OF WHEEL AND TYRE
Wheel hub
Dimension
Tyre
Dimension
Tyre
Pressure
(Kpa /PSI)
Front
Wheel
12×6.AT 25×8-12 70/10
Rear
Wheel
12×8.AT 25×10-12 70/10
• Since wheels and tyres are crucial to the
vehicle operation, inspection for tyre pressure
and profile depth is necessary.
• To ensure maximum security and longer life
expectancy of the wheel, please periodically
inspect the tyre pressure and profile depth.
Insufficient tyre pressure can result in not only
intensified wearing of the tyre but also
instability during the course of operating the
vehicle (such as hard turning). Excessive tyre
pressure can also reduce the friction force
between the tyre and ground, causing spinning
or lose of control. Therefore, please ensure the
tyre pressure strictly complies with figures
shown in the chart above.
• Before operating the vehicle each time, please
check if profile depth of the tyre is over worn,
which might result in spinning, instability, lose
of control and other potential security risk of
the vehicle.
To Next Page
