Hologic Brevera - How to Access the Reimage Feature; How to Close a Patient; How to Use the Output Set; How to Select an Output Set

Brevera Breast Biopsy System User Guide
Chapter 4: User Interface - Imaging Display
MAN-04303-002 Revision 006 Page 53
4.3.6 How to Access the Reimage Feature
Select the Reimage button to acquire a new image of a specimen already in the tissue
filter chambers. Refer to How to Reimage on page 94 for more information.
4.3.7 How to Close a Patient
Select the Close Patient button. Select Yes to the confirmation prompt. The system
returns to the Select Patient screen and automatically saves to the configured output
devices any images that were not sent previously.
4.4 How to Use the Output Set
The images are sent automatically to the output devices in the selected Output Set when
a patient is closed.
4.4.1 How to Select an Output Set
Select an output device set like PACS, CAD devices, and printers from the Output Set
drop-down menu in the Procedure screen.
Note
Images are not sent if an Output Set is not selected.
4.4.2 How to Add or Edit an Output Set
Note
The configuration of Output Sets occurs during installation, but you can edit existing
groups or add new groups.
To add a new Output Set:
1. Access the Admin screen.
2. Select the Manage Output Groups button.
3. Select the New button, type the information, then select the output device(s).
4. Select the Add button. When the Update Successful message appears, select OK.
5. You can select any group to set as the default by selecting the Set As Default button.
To edit an Output Set:
1. Access the Admin screen.
2. Select the Manage Output Groups button.
3. Select the group to be edited.
4. Select the Edit button, then make the changes.
5. Select the Save button. When the Update Successful message appears, select OK.