EasyManuals Logo

HP 8360 L Series User Manual

HP 8360 L Series
429 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #248 background imageLoading...
Page #248 background image
(
PRESETJ
Function Group
INSTRUMENT STATE
Menu Map
NONE
Description
This
hardkey
(green) causes the swept CW generator to perform a
short version of self-test, and initializes the swept CW generator to
a standard starting configuration. Two states can be defined for the
standard configuration: Factory or User.
Press
(PRESET)
at any time to test the swept CW generator and
restore to a standard configuration. If the red LED adjacent to
the
(PRESET)
key (labeled INSTR CHECK) stays on after preset,
the swept CW generator failed self-test; refer to
HP
8360 B-Series
Swept Signal Generator/HP 8360 L-Series Swept CW Generator
Troubleshooting Guide.
Cycling power with the POWER switch does not have the same
effect as presetting the swept CW generator. Cycling power causes
the swept CW generator to display the programming language, the
HP-IB address, and the firmware revision date. After the swept CW
generator displays this data, it restores its configuration to the state
before power was turned off.
Programming Codes
SCPI: SYSTem:PRESet[:EXECute]
Analyzer: IP
See Also
Preset Mode Factory, Preset Mode User
“Changing the Preset Parameters” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Operating and Programming Reference P-9

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 8360 L Series and is the answer not in the manual?

HP 8360 L Series Specifications

General IconGeneral
BrandHP
Model8360 L Series
CategoryInverter
LanguageEnglish

Related product manuals