HP 8360 L Series - Page 289

Queries and turns the frequency offset off and on.
After *RST, the setting is OFF.
l FREQuency:SPAN <num>[freq
suffix]lMAXimumlMINimum~UPlDOWN
l FREQuency:SPAN? [MAXimumlMINimuml
Sets and queries the frequency span. See FREU : CENTER for more
information.
l FREquency:STARt Cnum> [freq suffix]
lMAXimumlMINimumlUPlDOWN
l FREQuency:STARt? [MAXimumIMINimuml
Sets and queries the START Frequency. See FREU : CENTER for more
information. *RST setting is MIN.
l FREquency:STEP:AUTO ONlOFFlllO
l FREQuency:STEP:AUTO?
Sets and queries the function switch that controls the calculation of
the frequency step size (FREQ:STEP:INCR). If the response is
AUTO ON, then the swept CW generator selects a step size that is
coupled to the frequency span. The *RST setting is ON.
l FREquency:STEP[:INCRement] <num>[freq
suffix] IMAXimumlMINimum
l FREQuency:STEP[:INCRement]?
Sets and queries the frequency step size to use for any node in the
frequency subsystem that allows UP and DOWN as parameters. Setting
this value explicitly causes a FRElJ:STEP:AUTO OFF command.
The *RST setting is automatically calculated from span.
l FREQuency:STOP <num>[freq
suffix]lMAXimumlMINimumlUPlDOWN
l FREquency:STOP? CMAXimumlMINimuml
Sets and queries the stop Frequency. See FREQ : CENTER for more
information.
*RST setting is MAX.
l 1NITiate:CONTinuous ONlOFFlllO
l INITiate:CONTinuous?
Sets and queries the state of the continuous initiation switch. This is
more commonly known as single or continuous sweep. This does not
affect a sweep in progress. *RST setting is OFF.
l INITiate[:IMMediate]
Causes the initiation of a sweep. Useful mainly in the 1NIT:CONT OFF
mode of operation (single sweep). By combining the *OPC, *WA1
facilities with the 1NIT:IMM command, the functionality of the
S-32 Operating and Programming Reference