SCPI
COMMAND SUMMARY
analyzer compatible language take sweep and single sweep command
can be achieved.
l
LIST:DWELl
(<num>[time
suffix]
IMAXimumlMINimum)l*8Ol
l
LIST:DWELl?
[MAXimumIMINimum]
Sets and queries the amount of time to dwell at each frequency.
The number of dwells can be queried with
LIST:DWELl:POINts?.
This dwell is the time after completing phaselock and turning RF
on before changing to the next frequency. After
“RST,
the value is
100
PS
(
MIN
).
l
LIST:DWELl:POINts?
[MAXimumIMINimum]
Returns the number of dwells entered using the
LIST:DWELl
command. After *RST returns a 1.
l
LIST:FREQuency
(Cnum>[freq
suffix]
IMAXimumlMINimum)l*801
l
LIST:FREquency?
Sets and queries a list of frequencies that the swept CW generator
phase locks to in the sequence entered when the list mode is selected.
*RST value is the (MAX +
MIN)/2.
l
LIST:FREquency:POINts?
[MAXimumIMINimum]
Returns the number of frequencies that have been entered into the
list frequency array. After *RST returns a 1.
l
LIST:MANual
<num>
l
LIST:MANual?
Sets and queries the list point number to go to and lock. The value is
a
unitless
value that is limited between 1 and the maximum number
of points in either of the three arrays. This command has no effect
unless the list mode is set to manual. This value may be bumped if
the number of list frequencies is changed. *RST value is 1.
l
LIST:MODE
AUTOlMANual
l
LIST:MODE?
Selects and queries whether the list is played back automatically or
manually as described
in LIST :
MANual.
Operating and Programming Reference S-33
To Next Page
Loading...
