SCPI
COMMAND SUMMARY
The *RST value is 0.
l POWer:SLOPe:STATe ONlOFFlllO
l
POWer:SLOPe:STATe?
Sets and queries the power slope state. *RST value is 0.
l POWer:SPAN
<num>[DB]
lMAXimumlMINimumlUPlDOWN
l POWer:SPAN?
[MAXimumlMINimum]
The coupling equations for power sweep are exactly analogous to
those for frequency sweep. Power sweep is allowed to be negative,
unlike frequency sweeps. *RST value is 0.
l POWer:STARt
<num>[lvlsuffixl
lMAXimumlMINimumlUPlDOWN
l POWer:STARt?
[MAXimumlMINimum]
Default units and units for query response are determined by the
command UNIT:POWer. The coupling equations for power sweep
are exactly analogous to those for frequency sweep. Power sweep is
allowed to be negative, unlike frequency sweeps.
*RST value is 0
dBm.
l POWer:STATe ONlOFFlllO
l
POWer:STATe?
Sets and queries the output power on/off state. “RST value is OFF.
a
POWer:STEP:AUTO ONlOFFlllO
l
POWer:STEP:AUTO?
Sets and queries the function switch that controls how the power step
size (POWer:STEP: INCRement) is determined. If in the automatic
state, then the step size is 1 dB. The *RST setting is ON.
l POWer:STEP[:INCRement]
<num>[DB]lMAXimumlMINimum
l
POWer : STEP [ :
INCRementI
?
[MAXimum
I
MINimumI
Sets and queries the power step size to be used for any node in the
power subsystem that allows UP and DOWN as parameters. Setting this
value explicitly causes POWer : STEP : AUTO OFF.
The *RST setting is 10 dB.
l
POWer : STOP
<num>
[lvl
suffix]
I
MAXimum
I
MINimum
l
POWer : STOP?
[MAXimum
I
MINimum]
Sets and queries the ending power for a power sweep.
1UPlDOWN
Default units
and units for query response are determined by the command
UNIT:POWer. The coupling equations for power sweep are exactly
analogous to those for frequency sweep. Power sweep is allowed to be
negative, unlike frequency sweeps. *RST value is 0
dBm.
l
ROSCillator:SOURce?
l
ROSCillator:SOURce
INTernallEXTernallNONE
Operating and Programming Reference S-39
To Next Page
Loading...
