Sets and queries the reference oscillator selection switch. The
command to set the switch will cause ROSC:SOUR:AUTO OFF to
be done also. The *RST value is automatically determined.
l ROSCillator:SOURce:AUTO ONIOFFlllO
l
ROSCillator:SOURce:AUTO?
Sets and queries the automatic reference selection switch.
The *RST value is 1.
l STATus:OPERation:CONDition?
Queries the Standard Operation Condition register.
l STATus:OPERation:ENABle
<num>
l STATus:OPERation:ENABle?
Sets and queries the Standard Operation Enable register.
The
STATUS
: PRESet value is 0.
l
STAT
US
:
OPERat
ion
[
:
EVENt]
?
Queries the Standard Operation Event Register. This is a destructive
read.
l
STATus:OPERation:NTRansition
<num>
l
STATus:OPERation:NTRansition?
Sets and queries the Standard Operation Negative Transition Filter.
The STATUS : PRESet value is 0.
l
STATus:OPERation:PTRansition
<num>
l
STATus:OPERation:PTRansition?
Sets and queries the Standard Operation Positive Transition Filter.
After
STATus:PRESet,
all used bits are set to
1s.
l
STATUS : PRESet
This command presets the following enable and transition registers:
MSIB,
OPERation,
QUEStionable,
and
SRECeiver.
ENABle
Is set to all
OS.
NTRansition
Is set to all
OS.
PTRansition
All bits used are set to
1s.
Unused bits remain
OS.
l
STATus:qUEStionable:CONDition?
Queries the Data Questionable Condition Register.
l
STATus:lJUEStionable:ENABle
Cnum>
l
STATus:DUEStionable:ENABle?
S-40 Operating and Programming Reference
To Next Page
Loading...
