HP 8360 L Series - Page 298

SCPI COMMAND SUMMARY
Sets and queries the Data Questionable SRQ Enable register.
The STATus:PRESet value is 0.
l STATus:QUEStionable[:EVENt]?
Queries the Data Questionable Event Register. This is a destructive
read.
l STATus:QUEStionable:NTRansition <num>
l STATus:QUEStionable:NTRansition?
Sets and queries the Negative TRansition Filter for the Data
Questionable Status Register. The STAT US :PRESet value is 0.
l STATus:QUEStionable:PTRansition <num>
l STATus:QUEStionable:PTRansition?
Sets and queries the Positive TRansition Filter for the Data
Questionable Status Register. After STAT US : PRESet, all used bits are
set to 1s.
Sweep Subsystem
Interactions between dwell, sweep time, points, step size, and
frequency span are as follows:
SWEep:TIME = (5 ms + SWEep:DWELl) x (SWEep:POINts - 1)
FREQ:SPAN = SWEep:STEP x (SWEep:POINts - 1)
DWELI
OFF
OFF
ON
SWEep:xx:AUTO switches
TIME
Switch Action
OFF
No coupling between SWEep:DWELl,
SWEep:TIME and SWEep:POINts.
ON No coupling between SWEep:DWELl,
SWEep:TIME and SWEep:POINts.
OFF
When SWEEP:TIME or SWEEP:POINts
are changed, SWEep:DWELl =
(SWEep:TIME / (SWEep:POINts - 1)) - 5 mS.
SWEep:DWELl is limited to 100 ps, minimum.
ON ON SWEep:DWELl = 100 hs (MINimum).
SWEep:TIME = 5.1 ms x (SWEep:POINts - 1)
l SWEep:CONTrol:STATe ONlOFFlllO
l SWEep:CONTrol:STATe?
Sets and queries the state of the sweep control.
OFF
Normal source mode.
ON
Use master slave source mode.
*RST value is OFF.
l SWEep:CONTrol:TYPE MASTerlSLAVe
a SWEep:CONTrol:TYPE?
Operating and Programming Reference S-41