6. Click Restore or Preview. Note that preview only checks if the replica can be
restored. It does not check if the database recovery will be successful.
Data Protector recovers the database after performing instant recovery by switching
the database to a mount state, restoring the necessary incremental backups and
archived redo logs from tape, and applying the redo logs.
If you reset the logs, reset the database; otherwise, Oracle will during the next backup
try to use the logs that were already reset and the backup will fail. Login to the target
and recovery catalog database and run:
rman target Target_Database_Login catalog
Recovery_Catalog_Login
RMAN> RESET DATABASE;
RMAN> exit
Oracle database recovery after the instant recovery
To recover the Oracle database after the instant recovery has been performed,
perform the following steps:
1. Put the Oracle database in a mount state by connecting to the target database
from the sqlplus and then running the following command:
startup mount
Data Protector Oracle ZDB integration142
To Next Page
Loading...
