database disks are never resolved during backup and this can cause such an instant
recovery to fail.
Configuring HP StorageWorks Enterprise Virtual Array
This section describes how to configure the Data Protector HP StorageWorks Enterprise
Virtual Array (EVA) integration for use with the VSS integration.
Prerequisites
• Install
HP storage components and licenses:
• HP StorageWorks Virtual Controller Software (VCS or XCS) and Command
View (CV) EVA. See the VCS and CV EVA documentation for installation
instructions. For information on supported product versions, see the latest
support matrices at http://www.hp.com/support/manuals.
• HP Operations Manager (HP StorageWorks SMI-S EVA provider part).
• HP StorageWorks Business Copy (BC) EVA microcode and license.
• If the alternate paths solution is used, install HP MPIO DSM for EVA.
• An EVA license for, at least, basic and snapshot operation.
• Install
Data Protector components and licenses:
• An instant recovery license.
• HP StorageWorks EVA SMI-S Agent. If this agent is not installed, only “Restore
using Microsoft Virtual Disk Service” (switch of disks) is possible.
For installation and licensing information, see the HP Data Protector installation
and licensing guide.
• Make sure the same operating system (and its version) is installed on the
application and backup systems.
• Connect EVA to the application and backup systems through the SAN. Backup
system must be connected to the same SAN as the EVA.
For supported backup and connectivity topologies, see HP Data Protector zero
downtime backup administrator's guide.
For general Data Protector and integration-specific limitations, see HP Data Protector
product announcements, software notes, and references.
Zero downtime backup integration guide 349
To Next Page
Loading...
Need help?
General