lower or equal number than the specified log
sequence or thread number are applied.
Selected SCN number: Only archive logs until the
specified SCN number are applied.
Open database after recovery Opens the database after the recovery was
performed.
Reset logs Resets the archive logs after the database is
opened. This option is by default not selected if
the Recover until option is set to Now.
The following are Oracle recommendations on
when to reset the logs:
Always reset the logs:
• After an incomplete recovery, that is, if not all
archive redo logs are applied.
• If a backup of the control file is used for
recovery.
Do not reset the logs:
• After a complete recovery, when the control
file is not used.
• If the archive logs are used for a standby
database. However, if you must reset the
archive logs, recreate the standby database.
Data Protector SAP R/3 ZDB integration224
To Next Page
Loading...
