You can restore different storage groups to original and different location in the same
restore session if the target restore client system is the same for all storage groups
involved.
During restore to original location, all stores in the storage group are dismounted,
even if only one store from the storage group will be restored. After restore, the stores
are left dismounted.
Prerequisites
• For restore to a different location, Inet must run under a domain account which
needs to be member of the following groups on the local system:
• Administrators
• Exchange Server Administrators
• While configuring restore to a different storage group in the Data Protector GUI,
only mounted stores are displayed in the Target drop-down list. To enable all
stores for target selection, mount the dismounted stores and click Reload in the
MS Exchange additional options.
IMPORTANT:
During a restore to a non-Exchange location and creation of a Recovery Storage Group
(RSG), Data Protector deletes an RSG that may already exists at the target location.
Limitations
Due to Microsoft Exchange Server limitations:
• Restore to an LCR or CCR storage group copy (Exchange Replication Service
instance) is not supported. Restore of an LCR or CCR copy to original location
will be performed to the location where original database resides (Exchange
Information Store).
• All stores in an RSG must originate from the same storage group.
• You cannot mount public folders to an RSG.
• Because only one storage group in an RSG is supported, only one storage group
can be restored with the option Restore to a non-Exchange location and create
RSG.
• When restoring to a different location, you cannot restore a specific database
store without the transaction logs. When a store is selected for restore, logs are
automatically included in the restore.
Integrating the Data Protector ZDB integrations and Microsoft Volume Shadow Copy Service390
To Next Page
Loading...
Need help?
General