HP MSR SERIES

124
Views
Ethernet interface view
Predefined user roles
network-admin
Parameters
user-number: Specifies the maximum number of concurrent 802.1X users on a port. The value range is 1
to 256.
Usage guidelines
Set the maximum number of concurrent 802.1X users on a port to prevent the system resources from being
overused. When the maximum number is reached, the port denies subsequent 802.1X users.
Examples
# Set the maximum number of concurrent 802.1X users on GigabitEthernet 2/1/1 to 32.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] dot1x max-user 32
Related commands
display dot1x
dot1x multicast-trigger
Use dot1x multicast-trigger to enable the 802.1X multicast trigger function.
Use undo dot1x multicast-trigger to disable the function.
Syntax
dot1x multicast-trigger
undo dot1x multicast-trigger
Default
The multicast trigger function is enabled.
Views
Ethernet interface view
Predefined user roles
network-admin
Usage guidelines
The multicast trigger function enables the device to act as the initiator and periodically multicast Identify
EAP-Request packets out of a port to detect 802.1X clients and trigger authentication. You can use the
dot1x timer tx-period command to set the interval for sending multicast Identify EAP-Request packets.
Disable the multicast trigger in a wireless LAN. Wireless clients and the wireless module of the network
access device can both initiate 802.1X authentication.
Examples
# Enable the multicast trigger function on GigabitEthernet 2/1/1.
<Sysname> system-view