74
[Sysname-radius-radius1] state secondary authentication block
Related commands
• display radius scheme
• radius-server test-profile
• state primary
timer quiet (RADIUS scheme view)
Use timer quiet to set the quiet timer for the servers specified in an RADIUS scheme.
Use undo timer quiet to restore the default.
Syntax
timer quiet minutes
undo timer quiet
Default
The server quiet period is 5 minutes.
Views
RADIUS scheme view
Predefined user roles
network-admin
Parameters
minutes: Specifies the server quiet period in minutes, in the range of 1 to 255.
Usage guidelines
Make sure the server quiet timer is set correctly.
• A timer that is too short might result in frequent authentication or accounting failures. The reason is
that the device will continue to attempt to communicate with an unreachable server that is in active
state.
• A timer that is too long might temporarily block a reachable server that has recovered from a failure.
The reason is that the server will remain in blocked state until the timer expires.
Examples
# Set the quiet timer for the servers to 10 minutes.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] timer quiet 10
Related commands
display radius scheme
timer realtime-accounting (RADIUS scheme view)
Use timer realtime-accounting to set the real-time accounting interval.
Use undo timer realtime-accounting to restore the default.
To Next Page
Loading...
Need help?
General
