HP MSR SERIES

433
aspf policy
Use aspf policy to create an ASPF policy and enter its view.
Use undo aspf policy to remove an ASPF policy.
Syntax
aspf policy aspf-policy-number
undo aspf policy aspf-policy-number
Default
No ASPF policy exists.
Views
System view
Predefined user roles
network-admin
Parameters
aspf-policy-number: Assigns a number to the ASPF policy. The value range for this argument is 1 to 256.
Examples
# Create ASPF policy 1 and enter ASPF policy view.
<Sysname> system-view
[Sysname] aspf policy 1
[Sysname-aspf-policy-1]
Related commands
• display aspf all
• display aspf policy
detect
Use detect to configure ASPF inspection for an application layer protocol or a transport layer protocol.
Use undo detect to restore the default.
Syntax
detect { dccp | ftp | gtp | h323 | icmp | icmpv6 | ils | mgcp | nbt | pptp | rawip | rsh | rtsp | sccp
| sctp | sip |sqlnet | tcp | tftp | udp | udp-lite | xdmcp }
undo detect { dccp | ftp | gtp | h323 | icmp | icmpv6 | ils | mgcp | nbt | pptp | rawip | rsh | rtsp
| sccp | sctp | sip |sqlnet | tcp | tftp | udp | udp-lite | xdmcp }
Default
ASPF does not inspect any application layer protocol or transport layer protocol.
Views
ASPF policy view
Predefined user roles
network-admin