HP MSR SERIES Command Reference

434
Parameters
dccp: Specifies Datagram Congestion Control Protocol (DCCP), a transport layer protocol.
ftp: Specifies FTP, an application layer protocol.
gtp: Specifies GPRS Tunneling Protocol (GTP), an application layer protocol.
h323: Specifies H.323 protocol stack, application layer protocols.
icmp: Specifies ICMP, a transport layer protocol.
icmpv6: Specifies ICMPv6, a transport layer protocol.
ils: Specifies Internet Locator Service (ILS), an application layer protocol.
mgcp: Specifies Media Gateway Control Protocol (MGCP), an application layer protocol.
nbt: Specifies NetBIOS over TCP/IP (NBT), an application layer protocol.
pptp: Specifies Point-to-Point Tunneling Protocol (PPTP), an application layer protocol.
rawip: Specifies Raw IP, a transport layer protocol.
rsh: Specifies Remote Shell (RSH), an application layer protocol.
rtsp: Specifies Real Time Streaming Protocol (RTSP), an application layer protocol.
sccp: Specifies Skinny Client Control Protocol (SCCP), an application layer protocol.
sctp: Specifies Stream Control Transmission Protocol (SCTP), a transport layer protocol.
sip: Specifies Session Initiation Protocol (SIP), an application layer protocol.
sqlnet: Specifies SQLNET, an application layer protocol.
tcp: Specifies TCP, a transport layer protocol.
tftp: Specifies TFTP, an application layer protocol.
udp: Specifies UDP, a transport layer protocol.
udp-lite: Specifies UDP-Lite, a transport layer protocol.
xdmcp: Specifies X Display Manager Control Protocol (XDMCP), an application layer protocol.
Usage guidelines
Repeat the detect command to configure ASPF inspection for multiple protocols.
For a multi-channel protocol, if you enable TCP or UDP inspection without configuring application layer
protocol inspection, the device might not be able to receive response packets. HP recommends that you
enable application layer protocol inspection together with TCP/UDP inspection.
For a single-channel protocol, such as Telnet, you only need to configure the transport layer protocol (TCP
or UDP) inspection.
Examples
# Configure ASPF inspection for FTP packets.
<Sysname> system-view
[Sysname] aspf policy 1
[Sysname-aspf-policy-1] detect ftp
Related commands
display aspf policy

HP MSR SERIES Specifications

General

Product Series	MSR Series
Manufacturer	HP
Category	Network Router
Ports	Varies by model
WAN Interfaces	Varies by model
LAN Interfaces	Varies by model
VPN Support	Yes
Firewall	Yes
Dimensions	Varies by model
Weight	Varies by model
Wireless Support	Varies by model
Management	Web-based, CLI
Power Supply	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing