HP MSR SERIES

485
Syntax
session log packets-active packets-value
undo session log packets-active
Default
The device does not output session logs based on the packet-based threshold.
Views
System view
Predefined user roles
network-admin
Parameters
packets-value: Sets the packet-based threshold in the range of 1 to 1000 mega-packets.
Usage guidelines
If you set both the traffic-based and time-based logging, the device outputs a session log when whichever
is reached. After outputting a session log, the device resets the traffic counter and restarts the interval for
the session.
If you set both the byte-based and packet-based thresholds, the last configuration takes effect.
Examples
# Configure the device to output session logs on a per-10-mega-packet basis.
<Sysname> system-view
[Sysname] session log packets-active 10
Related commands
• session log enable
• session log time-active
session log time-active
Use session log time-active to set the time-based session logging.
Use undo session log time-active to restore the default.
Syntax
session log time-active time-value
undo session log time-active
Default
The device does not output session logs.
Views
System view
Predefined user roles
network-admin