HP MSR SERIES

488
Connection limit commands
In this chapter, "MSR1000" refers to MSR1002-4. "MSR2000" refers to MSR2003, MSR2004-24,
MSR2004-48. "MSR3000" collectively refers to MSR3012, MSR3024, MSR3044, MSR3064.
"MSR4000" collectively refers to MSR4060 and MSR4080.
connection-limit apply
Use connection-limit apply to apply a connection limit policy to an interface.
Use undo connection-limit apply to remove the application.
Syntax
connection-limit apply { ipv6-policy | policy } policy-id
undo connection-limit apply { ipv6-policy | policy }
Default
No connection limit policy is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
ipv6-policy: Specifies an IPv6 connection limit policy.
policy: Specifies an IPv4 connection limit policy.
policy-id: Specifies the ID of a connection limit policy in the range of 1 to 32.
Usage guidelines
Only one IPv4 connection limit policy and one IPv6 connection limit policy can be applied to an
interface. A new IPv4 or IPv6 connection limit policy overwrites the old one.
Examples
# Apply the IPv4 connection limit policy 1 to GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] connection-limit apply policy 1
# Apply the IPv6 connection limit policy 12 to GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/1/1
[Sysname-GigabitEthernet2/1/1] connection-limit apply ipv6-policy 12
Related commands
• connection-limit
• limit