HP MSR SERIES

334
Views
IPsec transform set view
Predefined user roles
network-admin
Parameters
ah: Specifies the AH protocol.
ah-esp: Specifies using the ESP protocol first and then using the AH protocol.
ah: Specifies the AH protocol.
Usage guidelines
The two tunnel ends must use the same security protocol in the IPsec transform set.
Examples
# Specify the AH protocol for the IPsec transform set.
<Sysname> system-view
[Sysname] ipsec transform-set tran1
[Sysname-ipsec-transform-set-tran1] protocol ah
qos pre-classify
Use qos pre-classify to enable the QoS pre-classify feature.
Use undo qos pre-classify to restore the default.
Syntax
qos pre-classify
undo qos pre-classify
Default
The QoS pre-classify feature is disabled. QoS uses the new IP header of IPsec packets to perform traffic
classification.
Views
IPsec policy view, IPsec policy template view
Predefined user roles
network-admin
Usage guidelines
The QoS pre-classify feature enables QoS to classify packets by using the IP header of the original IP
packets.
Examples
# Enable the QoS pre-classify feature.
<Sysname> system-view
[Sysname] ipsec policy policy1 100 manual
[Sysname-ipsec-policy-manual-policy1-100] qos pre-classify