31
Default
The device does not include the idle cut period or online detection interval in the user online duration sent
to the server.
Views
ISP domain view
Predefined user roles
network-admin
Usage guidelines
Configure the idle cut period feature based on the accounting policy in your network.
If the user goes offline due to connection failure or malfunction, the user online duration sent to the server
is not the same as the actual online duration.
• If the session-time include-idle-time command is configured, the device adds the idle cut period or
user online detection interval to the actual online duration. The user online detection period is
supported only by portal authentication. The online duration sent to the server is longer than the
actual online duration of the user.
• If the undo session-time include-idle-time command is configured, the device excludes the idle cut
period or user online detection interval from the actual online duration. The online duration sent to
the server is shorter than the actual online duration of the user.
Examples
# Configure the device to include the idle cut period or user online detection interval in the online
duration sent to the server for the users in ISP domain test.
<Sysname> system-view
[Sysname] domain test
[Sysname-isp-test] session-time include-idle-time
Related commands
display domain
state (ISP domain view)
Use state to set the status of an ISP domain.
Use undo state to restore the default.
Syntax
state { active | block }
undo state
Default
An ISP domain is in active state.
Views
ISP domain view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General
