371
keychain
Use keychain to specify an IKE keychain for pre-shared key authentication.
Use undo keychain to remove the IKE keychain reference.
Syntax
keychain keychain-name
undo keychain keychain-name
Default
No IKE keychain is specified for an IKE profile.
Views
IKE profile view
Predefined user roles
network-admin
Parameters
keychain-name: Specifies an IKE keychain name, a case-insensitive string of 1 to 63 characters.
Usage guidelines
An IKE profile can reference up to six IKE keychains. An IKE keychain specified earlier has a higher
priority.
Examples
# Specify IKE profile 1 for IKE keychain abc.
<Sysname> system-view
[Sysname] ike profile 1
[Sysname-ike-profile-1] keychain abc
Related commands
ike keychain
local-identity
Use local-identity to configure the local ID, the ID that the device uses to identify itself to the peer during
IKE negotiation.
Use undo local-identity to delete the local ID.
Syntax
local-identity { address { ipv4-address | ipv6 ipv6-address } | dn | fqdn [ fqdn-name ] | user-fqdn
[ user-fqdn-name ] }
undo local-identity
Default
No local ID is configured for an IKE profile. An IKE profile uses the local ID configured in system view by
using the ike identity command. If the local ID is not configured in system view, the IKE profile uses the
IP address of the interface to which the IPsec policy or IPsec policy template is applied as the local ID.
To Next Page
Loading...
Need help?
General
