78
Usage guidelines
The VPN specified here applies to all servers in the RADIUS scheme for which no VPN is specified.
Examples
# Specify VPN test for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] vpn-instance test
Related commands
display radius scheme
HWTACACS commands
data-flow-format (HWTACACS scheme view)
Use data-flow-format to set the data flow and packet measurement units for traffic statistics.
Use undo data-flow-format to restore the default.
Syntax
data-flow-format { data { byte | giga-byte | kilo-byte | mega-byte } | packet { giga-packet |
kilo-packet | mega-packet | one-packet } } *
undo data-flow-format { data | packet }
Default
Traffic is counted in bytes and packets.
Views
HWTACACS scheme view
Predefined user roles
network-admin
Parameters
data { byte | giga-byte | kilo-byte | mega-byte }: Specifies the unit for data flows, which can be byte,
kilobyte, megabyte, or gigabyte.
packet { giga-packet | kilo-packet | mega-packet | one-packet }: Specifies the unit for data packets,
which can be one-packet, kilo-packet, mega-packet, or giga-packet.
Usage guidelines
The data flow and packet measurement units for traffic statistics must be the same as configured on the
HWTACACS accounting servers. Otherwise, accounting results might be incorrect.
Examples
# In HWTACACS scheme hwt1, set the data flow and packet measurement units for traffic statistics to
kilobyte and kilo-packet, respectively.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] data-flow-format data kilo-byte packet kilo-packet
To Next Page
Loading...
Need help?
General
