376
# Configure a peer ID with the identity type of IP address and the value of 10 .1.1.1 .
[Sysname-ike-profile-prof1] match remote identity address 10.1.1.1
Related commands
local-identity
pre-shared-key
Use pre-shared-key to configure a pre-shared key.
Use undo pre-shared-key to remove a pre-shared key.
Syntax
pre-shared-key { address { ipv4-address [ mask | mask-length ] | ipv6 ipv6-address [ prefix-length ] } |
hostname host-name } key { cipher cipher-key | simple simple-key }
undo pre-shared-key { address { ipv4-address [ mask | mask-length ] | ipv6 ipv6-address
[ prefix-length ] } | hostname host-name }
Default
No pre-shared key is configured.
Views
IKE keychain view
Predefined user roles
network-admin
Parameters
address: Specifies a peer by its address.
ipv4-address: Specifies the IPv4 address of the peer.
mask: Specifies the mask in dotted decimal notation. The default mask is 255.255.255.255.
mask-length: Specifies the mask length in the range of 0 to 32. The default mask length is 32.
ipv6: Specifies an IPv6 peer.
ipv6-address: Specifies the IPv6 address of the peer.
prefix-length: Specifies the prefix length in the range of 0 to 128. The default prefix length is 128.
hostname host-name: Specifies a peer by its hostname, a case-sensitive string of 1 to 255 characters.
key: Specifies a pre-shared key.
simple: Specifies a pre-shared key in plain text.
simple-key: Specifies a plaintext key. In non-FIPS mode, it is a case-sensitive string of 1 to 128 characters.
In FIPS mode, it is a case-sensitive string of 15 to 128 characters, and it must contain uppercase and
lowercase letters, digits, and special characters.
cipher: Specifies a pre-shared key in cipher text.
cipher-key: Specifies a ciphertext key. In non-FIPS mode, it is a case-sensitive string of 1 to 201 characters.
In FIPS mode, it is a case-sensitive string of 15 to 201 characters.
To Next Page
Loading...
Need help?
General
