HP MSR SERIES - IKE Commands; Authentication-Algorithm; Authentication-Method

351
IKE commands
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for features,
commands, and parameters might differ in FIPS mode and non-FIPS mode. For more information about
FIPS mode, see Security Configuration Guide.
authentication-algorithm
Use authentication-algorithm to specify an authentication algorithm for an IKE proposal.
Use undo authentication-algorithm to restore the default.
Syntax
In non-FIPS mode:
authentication-algorithm { md5 | sha }
undo authentication-algorithm
In FIPS mode:
authentication-algorithm sha
undo authentication-algorithm
Default
The IKE proposal uses the authentication algorithm of HMAC-SHA1.
Views
IKE proposal view
Predefined user roles
network-admin
Parameters
md5: Specifies HMAC-MD5 as the authentication algorithm.
sha: Specifies HMAC-SHA1 as the authentication algorithm.
Examples
# Specify HMAC-SHA1 as the authentication algorithm for IKE proposal 1.
<Sysname> system-view
[Sysname] ike proposal 1
[Sysname-ike-proposal-1] authentication-algorithm sha
Related commands
display ike proposal
authentication-method
Use authentication-method to specify an authentication method to be used in an IKE proposal.